Questions & Answers

• Question:

  Will my low impedance (low Z) Grado headphones work with N22?

  Answer:

  Yes, the N22 will work well with headphones or earphones with an impedance from 16 to 300 ohms.

• Question:

  Can I increase the length or change the speaker wire between the N22 and each speaker?

  Answer:

  Sure. We've included two 5-foot, 16-gauge speaker wires with the N22 but any "stranded" speaker wire will work. The standard-size speaker binding posts on the back of the amp will accept bare stranded wire, however if you want to terminate the wires we recommend using spade or pin-type terminals.

• Question:

  Can I connect a subwoofer to the N22?

  Answer:

  Yes, simply connect the full-range output of the N22 into your sub's line-level input. The sub and speaker volume can be controlled together by the N22 volume control.

• Question:

  Is it possible to use the N22 amp to power the rear channels of my surround system?

  Answer:

  Yes, the N22 amp + P4 passive speakers + W1 or W3 wireless stereo adapter will make a great-sounding wireless rear channel setup.

• Question:

  Is it OK to remove the stand attached to the N22 and place the amp on it's side?

  Answer:

  The N22 needs to be kept upright with the stand attached for proper cooling.